Directv HR10-250 Manuel d'utilisateur télécharger pdf (Page 125)

Setting a Remote Address

115

Setting a Remote Address

If you have two HD DVRs in the same house, you may want to assign a remote address to

each remote control. This will prevent the crossing of signals between one HD DVR’s

remote and the other’s.

1. If the HD DVRs are both in the same room, cover the area around the shiny, dark

plastic window on the front of one HD DVR. You can use a piece of cloth, a magazine,

or anything thick and opaque. This prevents the HD DVR from receiving signals.

2. Point the remote control at the HD DVR for which you want to set the remote address.

Press the DIRECTV button, and select Messages & Setup. Select System Information,

and press the DOWN arrow until you see Remote Address.

3. Point the remote control away from the HD DVRs, and cover the front end of the

remote with your hand. Press and hold the PAUSE and DIRECTV buttons until the red

light at the end of the remote control comes on and stays on when you release them.

4. Point the remote control at the HD DVR for which you want to set the remote address,

and press the number “1.” Press the RIGHT arrow. On the screen, the Remote Address

changes to 1. Exit System Information by pressing the DIRECTV button.

5. Repeat steps 1-4 on the second HD DVR and its remote control, pressing the number 2

for the second remote address.

The remote controls are now set to send signals exclusively to the HD DVR for which

they are addressed. You may want to label the remote controls so that you remember

which HD DVR they control. Addresses 1 to 9 are unique. 0 is a universal address,

meaning it will try to control any HD DVR that “hears” its signal.

If you do not exit System

Information before you go to

step 5, you may transmit information to

the original HD DVR and overwrite the first

address you entered.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 187 188

Pas de commentaire

Directv HR10-250 Manuel d'utilisateur Page 125