Directv HR10-250 Manuel d'utilisateur télécharger pdf (Page 120)

Programming the Remote ControlChapter 7

110

Introduction

For information about the individual buttons on the remote control, please refer to the

inside front cover of this guide. Before programming the remote control, you must first

insert the batteries and complete Guided Setup.

Using the Remote with a TV and A/V Receiver

The DIRECTV Remote will already work with your DIRECTV

HD DVR. You can also

set it up to control your TV and A/V receiver. For example, you can set up the remote to:

• Control TV power, volume, mute, and input settings: Complete the instructions on

page 111 using the first column in each of the tables (TV power, volume, and mute).

Then repeat the instructions using the second column (TV input).

• Control TV and A/V receiver power; A/V receiver volume and mute: Complete the

instructions on page 111 using the first column in each of the tables. Then repeat the

instructions using the third column (A/V receiver power, volume, and mute). In this

case, the TV POWER button turns on/off both the TV and the A/V receiver. The VOL

and MUTE buttons control only the A/V receiver.

• Control TV power and A/V receiver volume and mute: Complete the instructions on

page 111 using the first column in each of the tables. Then repeat the instructions using

the fourth column (A/V receiver volume and mute). The VOL and MUTE buttons

control only the A/V receiver.

The SAT/TV switch sets the remote control to send channel changing signals to either the

HD DVR (SAT) or the television (TV). If you program the remote to control the volume

on the A/V receiver, it continues to control the A/V receiver’s volume when you change

the SAT/TV switch to TV.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 187 188

Pas de commentaire

Directv HR10-250 Manuel d'utilisateur Page 120