Directv HR10-250 Manuel d'utilisateur télécharger pdf (Page 32)

Chapter 2

Guided Setup

Welcome!

Now that you have finished connecting your DIRECTV

HD DVR, you are ready to begin

Guided Setup. When you first plug in the HD DVR, you will see gray screens which

display its progress as it starts up. After a few minutes, you will see the Welcome screen,

which marks the start of Guided Setup. If you do not see the Welcome screen, refer to the

troubleshooting tips on page 119.

Remember, while a cable is connected to the HDMI Output jack, the standard video

output jacks (S-Video and Composite A/V) will only display video at “480i,” and the

Component Video output is disabled. (You can’t view video from both the HDMI Output

and the Component Video Output at the same time.) If you used the HDMI or HDMI-to-

DVI cable to connect your HD DVR to your TV, make sure your TV is set to display

video from the input jack you used.

During Guided Setup, follow the on-screen instructions to point your satellite dish antenna

(if you haven’t already), activate your DIRECTV

programming and DIRECTV

DVR

with TiVo

service, select your default video output format, and set up your HD DVR’s

phone connection. Use the remote control to select menu items and move through setup

screens. If you need additional assistance, this chapter contains detailed instructions.

Guided Setup includes four basic steps, described in this chapter:

• Satellite Dish Guided Setup

• Activate Services

• Off-Air Channels and Video Setup

•Phone Setup

When you see the Welcome screen, press SELECT to start Guided Setup.

For information about the remote

control, see “Introducing the

Remote Control” on the inside front cover

of this guide.

Your HD DVR must be connect to a

standard phone line to complete

Guided Setup.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 187 188

Pas de commentaire

Directv HR10-250 Manuel d'utilisateur Page 32